Door cover is also called door frame, its role is to fix the door fan, play the role of protecting the door fan and protecting the corner, so that the door is not scratched, damaged, etc. How do you fasten the door cover to the wall? The following small series for you to introduce the wood plastic door fixed process in detail, I hope to help you.

1. Basic framework.

Choose firm wood core to do core material, by original good door cover size cut into wait for width small, make it the basic frame of doorcase. First determine the position, mark horizontal lines on the wall with an infrared level instrument, and then measure the size of the door, both sides of the ink fountain vertical.

2. Look over the wall.

When the door cover is fixed and installed, the inflatable drill is punched on the wall, plus the wooden wedge, remember to make a mark at this time. At this time in each direction of the door cover vertical horizontal installation, ensure that the right Angle of the door frame is straight, and then put the nail through the door frame, nail into the wedge, the door frame fixed to the wall.

3. Three layers of overlap.

After the basic frame of the door cover is fixed, it can be stacked, which is more convenient to open and close the door later, the distance is about 4-5cm.

4, stick the panel.

How to fasten the door cover to the wall? After the installation of the above process, start to paste the panel (check the panel of the same door is similar color difference, the edge has no burr), in the door set fixed in the first measure the size, and then cut the panel, the junction gap is tight.

5, install the wooden line.

Once affixed, you can begin to install the wood grain board. With 1CM spacing from inside to outside to leave a distance, mark, and cut according to the mark, this will make the whole door more beautiful. The door cover is fixed and installed in this period of time, we must pay attention to the space between the door frame and the ground about 5CM, to ensure that other processes are carried out normally, such as ground leveling, sticking the floor or tiles, there can be enough space.

6. Door stopper.

Use a nail gun to nail the door cover line to the door cover line, and then fix the entry stop line and mute bar. The door cover is fixed and installed just before and after the joint of the door frame line, pay attention to not all nail in one time, otherwise it will cause the door frame to skew, saw off the excess cork.

7, the surface is clean.

After the door cover is installed, do a good job of cleaning the surface of the wooden door cover.

Above is the door fixed process I sorted for you, how to fix the door on the wall you know? According to the above steps, in fact, the installation of wooden door cover is relatively simple, need to remind friends, such as the need to measure the size of the door, otherwise it is likely to lead to wooden door cover and door can not chimeric. If the heart is not bottom, or suggest to find a professional master to install more reliable oh.